Thoughtful delivery service

Easy 30 day returns

Certified Reviews

Description

Sammy-C21 V1.0 Duet3D ModuleThis is the Duet3D version of the Sammy C21 module with a preloaded Duet3D bootloader. Sammy C21 V1. 0 is a versatile and very compact small (just 18x38mm size!) microcontroller board with the SAMC21G18A microcontroller, CP2102 USB UART converter, and two CAN2. 0 CAN FD standard compatible CAN bus transceivers. All relevant controller signals are available on pin headers. 16MHz XTAL and 32768Hz TOSC watch crystal are included. The Atmel Microchip SAM

2 pins usable as I2C or GPIO Almost unlimited expansion via CAN-connected expansion boards Via I/O ports only and CAN bus Via I/O ports only and CAN bus SD card interface speed 20Mbytes/sec 15Mbytes/sec 25Mbytes/sec 22

Same for whatever method you use to cut/shred your prints - any metal debris you get in the shredded plastic ends up in filament

SuperVolcano nozzles are super fast printing nozzles for use with the SuperVolcano block and packs to print large layer heights and at extremely high flow rates

- 1 x Revo HeaterCore 12V or 24V

allowing you to switch out

The housing parts are professionally SLS printed in nylon for maximum strength and precision

Cables included are linked here

The PSU uses a standard IEC inlet

Gathering information & firmware setting will be an easy task

combining them into a single

ZL set contains:

tighten it 1/32nd of a turn and NO MORE

Exchange/Return Notes